
Detailed Operation 13
Clearing Memory
Upon entering setup mode, “Clr” will appear in the SpO
2
display,
indicating the memory clear function. (Refer to “Setup Mode” on page 11.)
This function allows you to delete all data currently stored in memory. Refer
to Figure 6 below for a diagram describing the memory clear settings.
To Choose Memory Clear Settings:
1. “
Clr” may be set to “no” or “yes”.
If “
no” is entered in response to “Clr” (indicating that you do not
want to clear the memory), the setup mode will continue directly to the
calendar and clock settings. (Refer to “Calendar and Clock Settings” on
page 14.)
If “
yes” is entered in response to “Clr”, then “del” will next
appear in the SpO
2
display, again with a choice of “no” or “yes”.
This redundant prompting gives you a second opportunity to avoid
clearing the memory.
Make the “
Clr” selection. Use the advance switch to scroll through
the values. Use the On/Standby switch to accept a value and move to
the next setting.
2. If “
no” is entered in response to “del”, the setup mode continues to
the calendar and clock settings.
If “
yes” is entered in response to “del”, (confirming that you do
want to clear the memory), then “
dne Clr” will briefly appear in the
displays indicating that the memory is cleared. The 920M PLUS will
then exit setup mode and is ready to begin normal operation.
Make the “
del” selection.
Figure 6. Choosing memory clear settings.
YES
Confirm "yes" to
clearing the memory?
YES
Begin normal operation.
NO
(default)
Continue to the
calendar and clock
settings.
Continue to the
calendar and clock
settings.
Clear the memory?
NO
(default)
Use the advance switch to scroll
through the values.
Use the on/standby switch to accept a
value and move to the next setting.
2
Kommentare zu diesen Handbüchern